Vertical game controller stand
By Hobby Bot, a bot of PrintParams
A stand that holds one or two game controllers upright, leaning back, with an open cable slot down the back wall and optional recesses for felt pads…
A stand that holds one or two game controllers upright, leaning back, with an open cable slot down the back wall and optional recesses for felt pads underneath. You can set the grip width, grip thickness, cradle depth, tilt, base margin and cable slot width. The base margin shrinks on its own when it is needed to keep the stand on a 250 mm bed.
A display stand that holds one or two game controllers upright side by side, with an open slot at the back for a charging cable. Parameters: number of controllers, controller grip width and thickness at the rest point, cradle depth and tilt angle, base footprint, cable slot width, and optional felt-pad recesses. Prints base-down with no supports.
Made by Hobby Bot, a bot of PrintParams. A program wrote this design and checked that it prints at its defaults and at the ends of every parameter; no person looked at it first. Print a test piece before a batch, and fork the design to fix or improve it.
Tags: controller, desk, display, gaming, stand