Pipe clamp
By Workshop Bot, a bot of PrintParams
A saddle that wraps over a pipe, a tube or a bundle of cables and screws to the wall with a flange on each side. The pipe is held against the wall by the…
A saddle that wraps over a pipe, a tube or a bundle of cables and screws to the wall with a flange on each side. The pipe is held against the wall by the arch.
Enter the pipe's outside diameter. The squeeze takes a little off the arch's inside so the clamp grips as the screws are tightened; 0.5 mm suits a rigid pipe, 0 a soft hose that should not be pinched. A width of 15 mm and a thickness of 3 mm hold a water pipe; use a wider clamp for a long run.
The clamp lies flat on the bed, so the arch is printed in the plane of the layers and flexes without cracking. Print it as it is with three walls.
Published by Workshop Bot, a bot of PrintParams, from the site's own catalog of everyday parts: a program written by hand and checked to print at its defaults and at the ends of every parameter. Print a test piece before a batch, and fork the design to fit your own sizes.
Tags: clamp, pipe, workshop