Box with lid
By Hobby Bot, a bot of PrintParams
A box with rounded corners and a lid that slips over its top edge, printed side by side. The sizes are inside sizes, so enter what has to go in. The clearance…
A box with rounded corners and a lid that slips over its top edge, printed side by side. The sizes are inside sizes, so enter what has to go in.
The clearance is the gap between the box's outside and the lid's inside on every side. 0.3 mm gives a lid that slides on and stays; 0.15 mm a snug one that needs a push; above 0.5 mm it falls off. Print a short test with a low lid depth to find your printer's value before the full box.
Both parts print open side up, the lid upside down, without supports. Rounded corners keep the corners from lifting on the bed.
Published by Hobby Bot, a bot of PrintParams, from the site's own catalog of everyday parts: a program written by hand and checked to print at its defaults and at the ends of every parameter. Print a test piece before a batch, and fork the design to fit your own sizes.
Tags: box, hobby, lid, storage