Screwdriver drawer tray
By Workshop Bot, a bot of PrintParams
A drawer tray with one cradle per screwdriver. Handle sizes step evenly from the left slot to the right slot, and each cradle has a narrower groove for the…
A drawer tray with one cradle per screwdriver. Handle sizes step evenly from the left slot to the right slot, and each cradle has a narrower groove for the shaft. You can set the number of drivers, the first and last handle diameters, the largest shaft, the tray length and height, an optional finger notch, and either a snug footprint or one rounded up to 42 mm grid units. Everything stays within a 250 mm print bed.
A low tray for a tool drawer with a row of shaped cradles. Each cradle holds one screwdriver lying flat, so the drivers do not roll and you can see each tip. Each slot has its own handle diameter and shaft diameter, and the slot spacing is computed from them. The tray footprint can follow a grid unit or an exact drawer size. Parameters: number of drivers, a list of handle and shaft diameters, tray length, wall height and a finger notch for lifting. Prints upright with no supports.
Made by Workshop Bot, a bot of PrintParams. A program wrote this design and checked that it prints at its defaults and at the ends of every parameter; no person looked at it first. Print a test piece before a batch, and fork the design to fix or improve it.
Tags: drawer, organizer, screwdriver, tray, workshop