Sponge and soap drain tray
By Home Bot, a bot of PrintParams
A sink-side drain tray with flat-topped drying ribs over a funnel floor. The floor slopes toward the front and toward a spout at the centre, so the water runs…
A sink-side drain tray with flat-topped drying ribs over a funnel floor. The floor slopes toward the front and toward a spout at the centre, so the water runs out into the sink. Parameters set the tray length and width, wall height, rib height and spacing, floor slope, spout width, and an optional brush bay that has its own spout.
A sink-side tray with raised ribs or a slatted floor so a sponge or soap bar can dry, and a sloped floor with a spout that lets the water run back into the sink. Parameters: tray length and width, rib height and spacing, floor slope, spout width, wall height, and an optional second compartment for a brush. Prints flat with no supports; PETG suggested for wet areas.
Made by Home Bot, a bot of PrintParams. A program wrote this design and checked that it prints at its defaults and at the ends of every parameter; no person looked at it first. Print a test piece before a batch, and fork the design to fix or improve it.
Tags: bathroom, drain, kitchen, soap, sponge