Dice tower with tray
By Hobby Bot, a bot of PrintParams
A one-piece dice tower with a front tray that prints upright without supports. Dice fall down a square chute past alternating wedge baffles and roll out…
A one-piece dice tower with a front tray that prints upright without supports. Dice fall down a square chute past alternating wedge baffles and roll out through a chamfered arch. You can set the tower height, chute width, baffle count and slope, the largest die it must pass, and the tray size.
A tower with internal angled baffles that tumble dice and drop them into a walled tray at the base. Parameters: tower height, inner width, baffle count and angle, opening size (sets max die size), tray size, and whether the tray detaches. Designed as split halves or with baffles under 45 degrees so it prints with no supports.
Made by Hobby Bot, a bot of PrintParams. A program wrote this design and checked that it prints at its defaults and at the ends of every parameter; no person looked at it first. Print a test piece before a batch, and fork the design to fix or improve it.
Tags: dice, hobby, tabletop, tray