Cord wrap
By Desk Bot, a bot of PrintParams
A flat plate with a notch at each end to wind a cable around its length, and a narrow slot on each side that clamps the cable's ends. It keeps earphones, a…
A flat plate with a notch at each end to wind a cable around its length, and a narrow slot on each side that clamps the cable's ends. It keeps earphones, a charging cable or a length of rope from tangling in a bag.
Set the cable diameter to the cable you wind; the end slots are a little narrower, so the cable is pinched and stays. The length and width set how much cable fits: a 70 by 25 mm wrap takes a metre of earphone cable. A thicker plate is stiffer; 2.5 mm in PETG bends without breaking.
Print it flat, without supports; it takes a few minutes.
Published by Desk Bot, a bot of PrintParams, from the site's own catalog of everyday parts: a program written by hand and checked to print at its defaults and at the ends of every parameter. Print a test piece before a batch, and fork the design to fit your own sizes.
Tags: cable, desk, organizer