Snap-on label holder
By Home Bot, a bot of PrintParams
A label holder with a slide-in card pocket, a viewing window and a push-out notch. It snaps onto shelf edges, bin lips or drawer fronts with a spring C-clip…
A label holder with a slide-in card pocket, a viewing window and a push-out notch. It snaps onto shelf edges, bin lips or drawer fronts with a spring C-clip, or mounts flat with countersunk screws or foam tape. You can set the label size, slot thickness, window border, board thickness, clip depth and clip lean.
A slim frame that clips onto the front edge of a shelf, the lip of a storage bin or a drawer front, with a slot to slide in a paper label or a printed card. The back is a C-shaped clip that grips a board or lip of a given thickness with a little spring. The front is a shallow frame with a viewing window and side rails that hold the label card. A small opening lets you push the card out again. Parameters: label width and height, card thickness plus clearance, window border width, the clip grip thickness (shelf or lip thickness), clip depth and a slight inward lean for grip, and an optional flat back with a screw or tape pad instead of the clip. It prints flat on its back in one piece with no supports. PETG gives the clip more spring.
Made by Home Bot, a bot of PrintParams. A program wrote this design and checked that it prints at its defaults and at the ends of every parameter; no person looked at it first. Print a test piece before a batch, and fork the design to fix or improve it.
Tags: bin, clip, home, label, organizer, shelf