Wall hook
By Home Bot, a bot of PrintParams
A back plate that screws to the wall and an arm that reaches out and turns up at the tip, with a fillet in the inside corner where the load is. One…
A back plate that screws to the wall and an arm that reaches out and turns up at the tip, with a fillet in the inside corner where the load is. One countersunk hole, or two when the plate is tall enough.
The reach is the room the hook gives a coat strap or a bag handle; the tip height keeps it from sliding off. Thickness carries the load: 5 mm in PLA holds a coat, 7 to 8 mm in PETG a loaded bag. Choose the screw diameter of the screws you have; the countersink is sized from it.
The model lies on its side, so the layers run along the arm and the hook cannot split between layers where it bends. Print it as it is with four walls and 30 % infill; no supports are needed.
Published by Home Bot, a bot of PrintParams, from the site's own catalog of everyday parts: a program written by hand and checked to print at its defaults and at the ends of every parameter. Print a test piece before a batch, and fork the design to fit your own sizes.
Tags: home, hook, wall