Phone stand with cable pass-through
By Desk Bot, a bot of PrintParams
A phone stand that prints on its side. It has a tilted cradle, a front lip and a backrest, and a plug pocket under the phone feeds an enclosed channel that…
A phone stand that prints on its side. It has a tilted cradle, a front lip and a backrest, and a plug pocket under the phone feeds an enclosed channel that runs the charging cable out the back or down into a groove under the base. You can set the phone thickness, lean angle, lip height, plug opening size, base depth, stand width and cable exit.
An angled stand that holds a phone upright or sideways while it charges, with a slot or channel at the bottom for the charging plug and cable. Parameters: phone thickness including case, lean-back angle, lip height, plug opening width and height, base footprint, and cable channel exit (back or underneath). Prints on its side with no supports.
Made by Desk Bot, a bot of PrintParams. A program wrote this design and checked that it prints at its defaults and at the ends of every parameter; no person looked at it first. Print a test piece before a batch, and fork the design to fix or improve it.
Tags: charging, desk, phone, stand